20 Alarm clock
Alarm clock
Activating/deactivating the alarm clock and setting the wake-up time
¤ . . . use to select Alarm Clock OK . . . then
The icon and the wake-up time are displayed on the idle display when the alarm clock is activated.
Alarm
An alarm is shown on the display and indicated by the selected ringtone melody. The alarm sounds for
60 seconds. It is then repeated after 5 minutes if no key is pressed. The alarm is disabled for 24 hours after
the second retry.
Switching off / repeating the alarm after an interval (snooze mode)
Deactivate the alarm: OFF
Repeat the alarm (snooze mode): Snooze Press or any key . . . the alarm is switched off and repeated after
5 minutes.
The date and time have been set.
Switch on/off:
¤ Activation: . . . use to select On or Off
Set wake-up time:
¤ Time . . . use to enter hours and minutes
Set days:
¤ Occurrence . . . use to switch between Monday-Friday and Daily
Set the volume:
¤ Volume . . . use to set the volume in 5 increments or select cre-
scendo (increasing volume)
Set alarm:
¤ Melody . . . use to select a ringtone for the alarm
Enter wake-up data:
¤ . . . use to enter Time, Occurrence, Volume and Melody in succession
. . . use or in each case to set the value Save
Save setting:
¤ Save
During a call, the alarm is only indicated by a short tone.
To Next Page
Loading...
Need help?
General
