Machine Model
Description Part Number
UNIMIG Workshop 345SWF KUM345SWF
CONTENTS PAGE No:
Safety 4
General Description 6
Operation 7
Parts List 9
Machine Parts 11
Welding Tips 12
Maintenance 14
Trouble Shooting 14
UNIMIG pursue a policy of continuous research and development, and therefore
reserve the right to change the specifications, or design, without prior notice.
*
3 year warranty power source.
YEARS Warranty
*
3
*** CAUTION ***
Do not heat, cut or weld tanks, drums or containers
until the proper steps have been taken to insure that such procedures will not cause
flammable or toxic vapours from substance inside. These can cause an explosion even
though the vessel has been “cleaned”.Vent hollow castings or containers before heating,
cutting or welding. They may explode.
To Next Page
Loading...
