47
VIPER MULTI 165
OPERATING MANUAL
13. With a small movement rotate the gas cup forward so
that the tungsten electrode touches the workpiece.
14. Now rotate the gas cup in the reverse direction to lift
the tungsten electrode from the workpiece to create
the arc.
IMPORTANT! - We strongly recommend that you check for gas leakage prior to operation of your machine. We
recommend that you close the cylinder valve when the machine is not in use.
Welding Guns Of Australia PTY LTD, authorised representatives or agents of Welding Guns Of Australia PTY LTD
will not be liable or responsible for the loss of any gas.
To Next Page