ULA
PLANNING AND
ASSEMBLY
INSTALLATION MANUAL
PAGE
APPENDIX B
PRO SERIES CLAMPS: ENDCLAMP AND FIRST MODULE
22
MIDCLAMP: Rotate midclamp assembly and slide
until clamp is against module frame. Do not tighten
nut until next module is in position. Ensure bolt is
perpendicular to rail.
INSERT MIDCLAMP ASSEMBLY: Insert 1/4" T-Bolt
into top slot of rail
INSTALL MIDCLAMPS: Midclamp is supplied as
an assembly with a T-bolt for module installation.
Clamp assemblies may be positioned in rail near
point of use prior to module placement.
PLACE ADJACENT MODULE AGAINST CLAMPS:
Modules must be tight against clamps with no gaps.
Tighten nut to required torque.
TORQUE VALUE
11 ft-lbs. No anti-seize.
POSITION INDICATOR - SERRATED T-BOLT:
Verify the T-bolt position indicator is perpendicular
to the rail.
To Next Page
Loading...
