ULA
PLANNING AND
ASSEMBLY
INSTALLATION MANUAL
PAGE
APPENDIX B
24
1. Position clamp to align T-bolt with
rail slot. Lower clamp and insert
T-bolt into rail slot
5. Tighten bolt.
Torque bolt to 15 ft-lbs.
2. Rotate clamp clockwise 2/3 of a
turn to engage T-bolt inside rail slot.
NOTE: If excessive force is applied in step 2, the
cap may over-rotate causing it to be mis-aligned
with the module frame. If this occurs, keep rotating
the cap clockwise until it returns to the original
position.
3. Slide clamp into position against
module.
4. Place second module.
INSTALLING THE ENDCLAMP
To Previous Page
Loading...
