EP- 45F Paper Folder Operation Manual
10.
321
Paper guide set screw
Paper feed table
Paper feed table lever
Paper eject roller
7.How to Use
7-1. Standard Folding of Standard-size Paper
7-1-1. Set the standard-size paper
,
7-1-2. Setting the paper ejection roller
.
Change the roller position to fit the paper size
Standard-size
paper
A3 A4/B4 B5/A5/B6
Non-standard-
size paper
Setting the designated position
according to the paper length
Set the standard-size paper. Loosen the paper
guide. Set screw and set the paper guide to fit the
width of the paper.
Stack the paper on the paper feed table with its
printed side facing up (its printed side down in
case of fold-out) after neatly arranging it. Make
the paper guide closely contact the paper, and
tighten the setscrew. Lower the paper feed table
lever to raise the table,
Move the paper ejection roller to the position that
fits the size of paper being used. If the roller
doesn’t run smoothly, change the roller position.
To Next Page
Loading...