Unitec EP-45F - Designation and Functions of Operation Panel

EP- 45F Paper Folder Operation Manual
5.
SPEED
10
CLEAR/RESET
SELECT
STORE
TYPE
1001000
RUN
START/STOP
JAM
TEST
1
NONE
1
7
8 9
11
12
13
5
6
2
4
15
3
10
14
4. Designation and Functions of Control Panel
No. Designation/Indication Function
1 Speed adjustment key Used for adjusting the speed.
2 Store key
Select Memory 1/2 stored folding position and the folding position
after adjustment is stored.
3 Memory 1/2 lamp Two special folding types are stored.
4 Select key
Used for selecting paper length, the feed position of table A and B,
indicating of the counter when the lights are off.
5 Paper length input mode lamp
It is on when paper length is input; If non-standard-size paper,
press CLEAR/RESET, input correct paper length.
6 Table A stopper move mode lamp It lights when the position of stopper of Table A can be adjusted.
7 Table B stopper move mode lamp It lights when the position of stopper of Table B can be adjusted.
8 +/–key Used for adjusting the position of the stopper of Table A and B,
9 Fold type key Six folding types & six types of paper can be selected and stored.
10 Numerical key1
Used for inputting the reduced number for subtraction counting and
the length of non- standard-size paper
11 Counter
Shows the number of sheets, the position of the stopper pin of
Table A and B, and paper size.
12 Clear/Reset key
Clears counter indication and resets error. When the Paper length
lamp is on, press this key, can input non-standard-size paper
length
13 Test key Test fold one sheet (stopper of Table A and B move to the position)
14 Start/Stop key Starts and stops the machine
15 Statues lamp
It lights when paper stock runs short, or indicates the location when
paper feed trouble occurs.