3.3.2 SCANNER:
The system software of terminal decodes all major bar code symbologies including Code 39, Code 128,
Codabar, Code 93, I25, EAN, UPC, China Post code, etc. Use the [→] key to toggle among selection in each
category, then press [ENT] to confirm.
SCANNER Enable / disable bar code decoding.
LASER TRIG MODE If NORMAL is selected, you must press and hold down trigger to scan barcode label. If
FLASH is selected, you can directly scan barcode label without pressing trigger key.
LASER AIM Enable / disable laser beam point target on a distance barcode.
VERIFICATION Enable / disable double check scanned barcode.
3.3.3 DISPLAY:
Enable/disable power-on logo displays when power-on.
3.3.4 KEYPAD:
Allow user to set UPPER / LOWER case of character.
3.3.5 BLUETOOTH:
Allow user to transmit and receive data via Bluetooth enabled devices.
BLUETOOTH Enable / disable Bluetooth function.
Config BT MODE: Determine the mode of operation to be SLAVE or
MASTER. If MASTER mode is selected, you can enable
/disable auto connection to available BT devices.
Addr Display the BT Address.
Search Find BT devices and addresses, then press [ENT] to connect,
[→] to select the next BT access, [ESC] to leave.
(Available only when HT630 in master mode)
Reset Restore factory default settings.
BT SETUP
Exit Leave the BLUETOOTH setting environment.
3.3.6 EXIT:
Leave the SET (setting) environment.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
