Unitech MS912+ - RoHS Statement; Waste Electrical and Electronic Equipment (WEEE)

- 9 - - 10 -
GETTING CONNECTED PINCODE SETUP
There are two modes of wireless communication:
Pincode Start
1. Press and hold the trigger for 1 second to activate the scanner.
2. Scan [DISCONNECT]
3. Scan [BT mode - SPP]; the scanner will emit several beeps.
4. Select “Wireless Scanner” from discovered device list.
The default pincode is “1234”.
5. Open serial communication software with com port
(see Device Manager) properly set up.
6. The scanner will beep twice to verify the connection.
. E042$
BT mode - SPP
*.E042$*
. E032$
*.E032$*
. E033$
*.E033$*
Disconnect
. E031$
*.E031$*
*$TX*
$TX
. E043$
BT mode - HID
*.E043$*
1. Press and hold the trigger for 1 second to activate the scanner.
2. Scan [DISCONNECT]
3. Scan [BT mode - HID]; the scanner will emit several beeps.
4. Select “Wireless Scanner” from discovered device list.
5. The Bluetooth application may prompt you to scan
a pincode(see PINCODE SETUP section) it generated.
6. The scanner will beep twice to verify the connection.
Scan numeric barcodes (see NUMERIC BARCODES section
on the next pages)
based on the pincode generated
by the Bluetooth application.
STEP 1
Pincode Stop
Enter
STEP 4
STEP 3
STEP 2
(Recommended)