- 51 -
3.6 Interleaved 2 of 5
3.6.1 Interleaved 2 of 5
To enable or disable Interleaved 2 of 5, scan the appropriate bar code below.
3.6.2 Set Lengths for Interleaved 2 of 5
The length of a code refers to the number of characters (i.e., human readable
characters), including check digit(s) the code contains. Lengths for I 2 of 5 may
be set for any length, one or two discrete lengths, or lengths within a specific
range. To set lengths via serial commands, see Setting Code Lengths Via
Serial Commands.
NOTE
When setting lengths, single digit numbers must always be preceded by a
leading zero.
One Discrete Length - Select this option to decode only those codes
containing a selected length. For example, select I 2 of 5 One Discrete
Length, then scan 1, 4, to decode only I 2 of 5 symbols containing 14
characters. Numeric bar codes begin on Appendix B. To change the selection
or cancel an incorrect entry, scan Cancel on Appendix B.
To Next Page
Loading...
