Unitech MSR206 - MSR206 BPC and Coercivity Settings

MSR206 Programmer’s Manual UDN PM017-U Rev.C.1
Section 6 – Command and response 2003/10/9
Page 13
Total 28 pages
Model 1, 2, 3, & 5
Models Description
MSR206-1 Track 2
MSR206-2 Track 2 & 3
MSR206-3 Track 1,2 & 3
MSR206-5 Track 1 & 2
19. Command: Get firmware version
Command code: <ESC> v
Hex code: <ESC> 76
Response: <ESC> [version]
Description: This command can get the firmware version of MSR206.
* [version] is a 5 bytes version number, format is “ REV?X.XX “
MSR206? = 0
MSR206HC? = H
MSR206HL? = U
20. Command: Set BPC
Command code: <ESC> o [tk1bit][tk2bit][tk3bit]
Hex code: <ESC> 6F [05-08][05-08][05-08]
Response: <ESC> 30 [tk1bit][tk2bit][tk3bit]
Description: This command is used to set the bit per character of every track.
21. Command: Set Hi-Co
Command code: <ESC> x
Hex code: 1B 78
Response: <ESC> 0
Description: This command is used to set MSR206HL status to write Hi-Co card.
22. Command: Set Low-Co
Command code: <ESC> y
Hex code: 1B 79
Response: <ESC> 0
Description: This command is used to set MSR206HL status to write Low-Co card.
23. Command: Get Hi-Co or Low-Co status
Command code: <ESC> d
Hex code: 1B 64
Response: <ESC> H -------to write Hi-Co
: <ESC> L ------- to write Low-Co
Description: This command is to get MSR206HL write status