Need help?Do you have a question about the Unitech MSR206 and is the answer not in the manual?
General| Type | Magnetic Stripe Reader |
|---|---|
| Interface | USB |
| Tracks | 1, 2, 3 |
| Card Standard | ISO 7811 |
| Data Rate | 9.6 kbps |
| Power Supply | Powered via USB |
| Operating System Compatibility | Windows, Linux, Mac OS |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20 to +60 °C |
| Humidity | 10% to 90% RH (non-condensing) |
| Certifications | CE, FCC |
Lists all accessories included in the MSR206 package for setup and operation.
Outlines the warranty terms for the MSR206, voiding if altered or modified.
Details the hardware and software requirements for running the MSR206 utility test program.
Provides step-by-step instructions for installing and running the MSR206 utility test program.
Covers essential commands for device reset, communication testing, and LED control.
Details commands for reading and writing data to magnetic cards.
Includes commands for specific LED control and device diagnostic tests like sensor and RAM.
Commands for setting leading zeros, checking them, erasing cards, and selecting BPI.
Commands for reading and writing raw data without ASCII decoding.
Commands to retrieve device model and firmware version information.
Commands to set BPC for tracks and configure Hi-Co/Low-Co write status.
Defines the structure of the data block, including command, card data, and status.
Details the character code and hex code format for card data across tracks.
Explains the meaning of different status byte values (OK, errors).
Illustrates the communication sequence for initializing and testing the MSR206.
Shows the communication flow for writing data to the MSR206 and magnetic card.
Demonstrates the communication sequence for reading data from the MSR206.
Provides detailed example and command structure for writing data to magnetic cards.
Explains how to convert card data to hexadecimal for raw data writing.
Table showing ASCII to HEX conversion for track one data.
Tables illustrating ASCII to HEX conversion for tracks two and three.
Procedure to set BPC for all tracks to 08 bits and present data for encoding.
Shows how track 1 data is transferred to HEX format with 08 bits.
Explains odd parity calculation for data and Longitudinal Redundancy Check (LRC).
Illustrates the HEX transfer of track 2 and 3 data using 08 bits.
Procedure to set BPC for tracks 1, 2, and 3 to 07, 05, and 05 bits respectively.
Shows how track 1 data is transferred to HEX format with 07 bits.
Illustrates the HEX transfer of track 2 data using 05 bits.
Shows how track 3 data is transferred to HEX format with 06 bits.
Procedure to set BPC for tracks 1, 2, and 3 to 06, 05, and 06 bits respectively.
Shows how track 1 data is transferred to HEX format with 06 bits.
To Next Page
