Unitech PA500 - Send Command to Decoding Chip

-
2.25. Send command to decoding chip
Function Description:
Send command to decoder chip. This is a variation of command HAM_SendCommand.
It will read a number of parameters and packet them as in following format and send it
to decoder chip.
Esc, parameter1, parameter2, …, BCC
The total number of parameters is specified by first parameter num.
Function call:
BOOL HAM_SendCommand2(BYTE num, BYTE parameter1, …);
Parameter: (input)
num: BYTE: number of total parameters
parameterx BYTE: Parameter
Parameter: (output)
Return:
TRUE = indicates the command has been successfully sent to queue to output.