29
Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Chapter 5
Advanced Settings
Performing a Hardware Reset
You may have to perform a reset if the device freezes (i.e., the device no
longer responds to the buttons or tapping on the screen).
A soft reset allows your device to get a fresh start, similar to rebooting a
computer.
This will restart your device and adjust memory allocation. All records and
entries are retained after a soft reset. Unsaved data in open programs may be
lost.
Performing a Warm Boot
1. Remove the stylus from its holder.
2. Lightly press the tip of the stylus to the reset button located at the right
side of the scan button.
Warm boot button
Performing a Cold Boot
A cold boot will erase all data and all programs you have added, and will
restore the device to the default factory settings.
Never perform a cold boot unless a warm boot does not correct your problem.
When you perform your next ActiveSync operation, you can restore any data
that you previously synchronized to your computer or you can restore data that
you backed up to a storage card.
To Next Page
Loading...
Need help?
General
