@
sales@utplindia.in
+91 7046223333 , 9427301436
www.utplindia.in
www
UT-1401
DP INDICATOR AND SENSOR
5
3. PROGRAMMING
3.1 Operation Interface
1. 7 segment Display 4 Digit 7 segment dedicated to display the present value. In Programing
mode it shows Parameter and its value.
PV
3. LOW When LED is On It indicates the status of, Low Value.
6. PASCAL
KEYS
8. MODE KEY MODE or Function key allows to access the programming group or
parameters. press this key to return to the normal view.
NORMAL VIEWS
9. ENTER KEY ENTER Key allows enter into the Parameter, moving from one parameter
to another or saving a new value of parameter or a status of parameter.
Press to change set point-2 in normal view.
10. UP KEY UP Key allows increasing the value of a digit selected or changing the
status of parameter in programming mode. Press to change set point-1 in
normal view
1 . PASS KEY1 PASS Key allows pass the digit of a value from right to left of a selected
parameter in programming mode. In some Parameter it also change or
decrease the value.
4. HIGH
5. COM
When LED is On It indicates the status of, High Value.
7. mmWc
When LED is It indicates the status ofBlink, Communication.
When LED is On It indicates, Value is in PASCAL unit.
When LED is On It indicates, Value is in mmWc unit.
010.0
PASS Key
UP Key
MODE Key
ENTER Key
DP Display
Relay Status LED
High Alarm
Low Alarm
COM LED
mmWC Unit Selected LED
Pascal Unit Selected LED
2. RELAY When LED is On It indicates the status of RELAY Output,.
To Next Page
Loading...