Unitech UT-1401 - Operational Modes; Configuration Mode

@
sales@utplindia.in
+91 7046223333 , 9427301436
www.utplindia.in
www
UT-1401
DP INDICATOR AND SENSOR
7
‘Configuration Mode’ will shown by pressing key, will be display and then by pressing or keyMode
4.1 Configuration Mode
4. OPERATIONAL MODES
Range / Values
Parameter
COnf
0000
CONFIGURATION MODE
Password for Config. Mode Parameters
Display
DP : DP SENSOR
Scroll the digit by key, Increase by key.
Range : Values between to0000 9999
Default Input : dp
1nP
DP
INPUT TYPE
Selection of the applied Input.
Change the type Up by key, Down by key.
Range : Input Type is as follows:
Default Value : 0000
tsp1
L on
ALARM 1 ACTION
Alarm activation direction.
Values :
Default Value : L on
: No decimal (1234)
0000
: Active in High
HoN
ON
OFF
PV
SV
ON
OFF
PV
SV
LON:
:ActiveinLow
LoN
HON:
: One decimal (123.4)
0001
: Two decimal (12.34)
0002
: Three decimal(1.234)
0003
SV-Hyst
SV+Hyst
Change the value by key, or by key.
tsp2
L on
ALARM 2 ACTION
Alarm activation direction.
Values :
Default Value : L on
: Active in High
HoN
:ActiveinLow
LoN
Active same as above
Increase by key, Decrease by key.
dp
0001
DECIMAL POINT SELECTION
Decimal Point resolution for display value.
Values :
Default Value : 0001
Change the value by key, or by key.
Un1T
MMWC
PRESSURE UNIT
Alarm Relay activation direction.
Unit :
Default Value :
: mmWC
MMWC
:PASCAL
PA
Active same as above
Change the value by key, or by key.
MMWC
nAdd
0001
NODE ADDRESS
Device Address for Communication
Values between:
Default Value :
0255
to
0000
Change the value by key, or by key.
0001