Unitech UT-1401 - Setup Mode

@
sales@utplindia.in
+91 7046223333 , 9427301436
www.utplindia.in
www
UT-1401
DP INDICATOR AND SENSOR
9
‘Setup Mode’ Mode will shown by pressing key, after Mode display.Conf
4.2 Setup Mode
sp2
Hys2
Range / Values
Parameter
setp
0000
SETUP MODE
Password for Setup Mode Parameters
Display
Scroll the digit by key, Increase by key.
Range : Values between to0000 9999
Default Value : 0000
ZERO
0000
ZERO or LOW DISPLAY VALUE [LINEAR INPUT]
Display value at Low Input applied.
NOTE : Applicable for Analog Linear input only.
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 0000
-
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 0100
-
span
0001
SPAN or HIGH DISPLAY VALUE [LINEAR INPUT]
Display value at High Input applied.
NOTE : Applicable for Analog Linear input only.
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 00 03
-
sp1
00 03
ALARM SET POINT # 1
Activation value for Alarm Relay-1
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 0002
-
Hys1
0002
HYSTERESIS ALARM # 1
Value Diff. between On and Off of Relay-1
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
-
ALARM SET POINT # 2
Activation value for Alarm Relay-2, 3 & 4
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 0002
-
HYSTERESIS ALARM # 2
Value Diff. between On and Off of Relay-2, 3 & 4
(According to Decimal point)
(According to Decimal point)
(According to Decimal point)
(According to Decimal point)
(According to Decimal point)
(According to Decimal point)
Scroll the digit by key, Increase by key.
Range : Values between to1999 9999
Default Value : 0000
-
ofst
0000
OFFSET TO PROCESS VALUE
This parameter Increase OR Decrease PV Display
(According to Decimal point)
0002
0002
Default Value : 00 05