LCD: [C] MAX
A signal sound is audible for every new minimum or maxi-
mum signal.
The highest signal is displayed.
LCD: [C] MIN
A acoustic signal is audible for every new minimum or
maximum signal.
The lowest signal is displayed.
LCD: [C] MAX-MIN
An acoustic signal is audible for every new minimum or
maximum signal.
The difference between the highest and the lowest value is
displayed.
To exit the CREST function, press the key for longer
than 1 s.
The automatic power off feature is not activated with-
in this function.
7.3 Automatic Power Off Function
All UNITEST Hexagon multimeters are equipped with the
automatic power off function. This function is activated
within approx. 17 minutes after: the last function key
pressing, turning the measurement function selection dial,
or if the measurement value falls 10 % below the measure-
ment range. To reactivate the multimeter, press the
key or switch the multimeter off and on again.
If the key is pressed at the same time as the multi-
meter is switched on, then the automatic power function is
deactivated.
63
Special Function
ENGLISH
To Next Page
Loading...
