2524
of the connect ( ) button will put the call
on hold. The caller stays on the line but there
is no audio transfer and the hearing aids
switch to the previous hearing program. Use
this mode to have a side conversation with a
person next to you without transmitting the
conversation to the person on the phone.
4. Transfer call
While in a phone conversation, a long press
of the access (
) button will transfer the
call to the phone. This allows you to hand
your phone to another person. Your hearing
aids will switch back to the previous hearing
program.
After holding or transferring a call, another long
press of the access (
) button transfers the call
back to the uDirect 2 and the call is resumed
through your hearing aids.
As long as the call is on hold or transferred, you
may use the access ( ) button to change your
hearing aid programs again.
Your hearing healthcare professional may
configure the following additional features on
uDirect 2. They will be assigned to a long press
(2 seconds) of the access (
) or the connect
(
) button:
Your phone must support these features. Please
consult the phone user manual for details.
1. Redial last number
A long press of the access (
) button will
redial the last dialed number.
2. Voice dial
A long press of the connect (
) button will
start the voice dial which allows you to speak
the person’s name instead of typing the
number.
When using two phones at the same time (multi
point) only the last paired phone can be used
for voice dial.
3. Hold call
While in a phone conversation, a long press
To Next Page
Loading...
Need help?
General
