5554
Caller identification: spoken caller
names
The uDirect 2 may be able to tell you the name
of the caller.
If your phone supports Phone Book Access
(PBA) or Phone Book Access Profile (PBAP), the
uDirect 2 will try to access information about the
caller every time the phone rings.
As the phone rings, the displayed
information is transferred to the
uDirect 2 and spoken through your
hearing aids as follows:
The stored name in your phone’s phonebook.
In the example, you will hear “Mike Office”.
The number if the name is not known.
To make sure the pronunciation is correct your
hearing healthcare professional can configure
the language settings of your uDirect 2.
The phonebook is not downloaded to the
uDirect 2. This way, uDirect 2 can also support
indicated on the uDirect 2 by the audio indicator
shortly blinking blue. A double-blink indicates
that two devices are connected to uDirect 2.
Deleting the pairing of Bluetooth devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uDirect 2, you may consider deleting the pairing
of devices to the uDirect 2.
1. Turn ON your uDirect 2.
2. Press and hold the (
) and ( ) buttons for
10 seconds until the blue rapid blinking audio
indicator stops.
Deleting the pairing of Bluetooth devices
removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
To Next Page
Loading...
Need help?
General
