98
Wearing the uDirect 2 correctly
Before any phone, music or TV streaming can
take place, the uDirect 2 must be switched ON
and worn correctly as shown below:
1. Put the neckloop around
your neck (easily done by
unplugging one neckloop
plug).
2. Make sure both plugs
are well connected in the
neckloop sockets.
3. Switch the uDirect 2 ON.
For streaming, the neckloop must always be
plugged in. When unplugged, the uDirect 2
will go into sleep mode after two minutes. The
power and audio indicators will stop blinking
and all active Bluetooth connections are
terminated to save power. Plug the neckloop in
again to activate the streaming.
uDirect 2 Bluetooth pairing
1. Switch ON ( ) the uDirect 2.
2. Press and hold the connect (
) and volume
(
) buttons simultaneously for 2 seconds until
the audio indicator starts to rapidly blink blue.
3. Start the pairing process on the Bluetooth
®
device (e.g., phone) within 1 minute according
to the devices user guide and use code
“0000” when prompted.
4. After successful pairing, the audio indicator
will stop rapidly blinking blue.
The pairing process does not require the neckloop
to be plugged in. For streaming and Bluetooth
connection, the neckloop is mandatory.
When pairing to a cellular phone, we recommend
disabling the phone key tones and SMS alerts.
2 sec
To Next Page
Loading...
Need help?
General
