5352
pairing may vary for each device. Please refer to
the device’s user guide or dealer support if you
cannot complete the pairing procedure with the
generic steps described below.
1. Turn ON both your uDirect 2 and the other
device.
2. Place them next to each other.
3. Set your device into Bluetooth pairing mode.
4. Initiate the pairing process on your uDirect 2
by simultaneously pressing the (
) and ( )
buttons for 2 seconds until the audio
indicator is rapidly blinking blue.
5. Your uDirect 2 will remain in the pairing
mode for two minutes or until the pairing is
completed.
6. If a passcode is required, enter “0000” (four
zeros).
After pairing, wait until the devices have
completed connection.
Confirmation of successful connection is
The connection between your uDirect 2 and
your phone will be maintained as long as the
two devices remain on and are within range of
each other. If either device is switched off or
moves out of range, you may need to repeat the
connection procedure.
Some phones may perform the connection
procedure automatically after pairing. We
recommend selecting “Yes” when prompted to
allow this device to connect automatically once
the pairing is completed.
Please consult your phone’s user guide in the
case where a manual connection is necessary.
Pairing with other external Bluetooth devices
If you want to use your uDirect 2 to listen to
music from your stereo system you may use an
external Bluetooth transmitter. The uDirect 2 can
also be used with a Bluetooth-enabled landline
phone.
The pairing procedure for other Bluetooth
devices is controlled by the device with which
you are attempting to pair. The procedure for
To Next Page
Loading...
Need help?
General
