5150
It may be necessary to redo the pairing if your
phone’s firmware was updated.
How to connect to a phone
Once your phone and uDirect 2 are paired (see
Pairing a Bluetooth-enabled phone), the phone
needs to be ‘connected’ to your uDirect 2 before
it will actually send audio signals to it.
This function should also appear in your phone’s
Bluetooth menu.
1. Ensure that the uDirect 2 is turned ON and the
neckloop is plugged in and worn correctly.
2. Locate the Bluetooth section in your phone
menu and select list of “paired devices”.
3. Locate and highlight your uDirect 2 and select
“Connect”.
4. Confirmation of successful connection is
indicated on the uDirect 2 by the audio
indicator blinking blue. Additionally a headset
symbol ( ) may appear on the main screen of
your phone.
the audio indicator starts to rapidly blink
blue.
6. Your uDirect 2 will remain in the pairing mode
for two minutes or until pairing is completed.
7. Your phone should present a list of Bluetooth
devices discovered. Select “Unitron uDirect 2”
from this list.
8. Your phone may then ask you to enter a
passcode. If so, enter “0000” (four zeros).
Some phones may ask which Bluetooth
service you want to enable. Select “Headset”
or, if available, “Stereo Headset”.
9. Your uDirect 2 should now be paired to your
phone and the audio indicator will stop
blinking.
The pairing process is independent of the
neckloop (it does not need to be plugged in).
2 sec
To Next Page
Loading...
Need help?
General
