www.urcsupport.com
4
is valid, the device key blinks twice. If
the key emits a single, long blink, then
the code entry was invalid. Try steps 2
and 3 again, using the same code.
5. Repeat steps 1 through 4 above for the
next device you want to control (either
your television or satellite receiver).
OPERATE YOUR SATELLITE RECEIVER
Your Polaris Remote Control is now ready to
operate your satellite receiver. You can use your
remote control to turn your satellite receiver on
and off, and to change the channel.
To change the channel, do the following:
4. Aim the remote control at the device
you want to control. Press the key for
that device once (either TV or SAT). If
the device turns off, then you have
successfully programmed your remote
control for that device. If the device
does not turn off, then repeat steps 2
through 4 using the codes listed for
your TV brand until you have found
the code for that device.
1.
To turn on your satellite receiver, press
SAT. The SAT key blinks once and your
satellite receiver turns on. To turn off
your satellite receiver, press SAT. The
SAT key blinks once and your satellite
receiver turns off.
1.
Use the remote control's CH+ and CH-
keys to navigate to the channel you
wish to view, one channel at a time.
StarChoicePolaris Remote Rev 1 FRA.fm Page 4 Monday, January 8, 2007 4:57 PM
To Next Page
Loading...
Need help?
General
