Universal Remote Control R7 - Auto-Search Code Setup

IMPORTANT: Vou now have 20 seconds to рейогт the next
step while vou are in set-up mode. If vou don't press a button
within 20 seconds, the LED light will turn off and exit the set-
up mode and vou will need to start over.
STEP 5: Point the remote toward the Component, (in this example
the TV), and punch in the 3-digit-code that vou wrote down for that
specific Component. Use the Number buttons 0-9 on the remote to
punch in the code. The TV LED light will blink each time a number is
pressed. This lets you know that the number has been successfully
entered.
Press Number
buttons to add
3-digit codes
Number
Buttons
If the 3-digit code number you just punched in is the correct number,
the component you are trying to program will turn off. If it did not turn
off, continue entering code numbers from your list until the TV turns
off.
IMPORTANT: If you tried all the set-up codes in the list and the
component still did not turn off, either the Auto-Search Method
(page 12) or the Learning Method (page 14) will help you.
10