Universal Remote Control URC-A6 User Manual

Page | 25
TransportControlPunchThrough
This punch through enables you to program
the URC-A6 remote so that DVD Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP
and RECORD) will also operate in other
component modes on the remote control.
STEP1: Press and hold the component
button you want to add Transport Control to,
such as [CABLE/SAT] or [TV], and the
SELECT [SEL] button at the same time for two
seconds until the Component light turns on.
STEP2: Press the [PLAY] button. The
Component light will blink once.
STEP3: Press either the [DVD] or [VCR]
button that you want to use as the source of
Transport Control. The component light will
blink three times to confirm it is saved.
Note: If you do not press a
button within 30 seconds, the component
light will turn off. The remote will exit the
programming mode, and you will have to
start over with step one.
Replace
with
high
quality
image

Universal Remote Control URC-A6 Specifications

General

Brand	Universal Remote Control
Model	URC-A6
Category	Remote Control
Language	English