Page | 44
This Owner’s Manual is designed to assist
you in programming your URC-A6 remote to
work with your components by guiding you
through an easy step-by-step process.
Everything you need to know about
programming the URC-A6 is contained in
this Manual.
Information to the User
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one more of the following measures:
● Reorient or relocate the receiving
antenna.
● Increase the separation between the
equipment and receiver.
● Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced
radio/TV technician for help.
Warning
Changes or modifications not expressly
approved by the manufacturer could void the
user’s authority to operate the equipment.
Note: The manufacturer is not responsible for
any Radio or TV interference caused by
unauthorized modifications to this
equipment. Such modifications could void
the user’s authority to operate the
equipment.
To Next Page
Loading...
Need help?
General
