5. Gas units
Gas Setup (Series 5)
B) Gas parameter modify at control
panel
Change the gas type setting by entering the
1
st
level hidden menu of the oven control
panel, as follows:
1. To enter the hidden menu, press
simultaneously the buttons for 5
seconds.
2. Press the button until the display
shows: 12 – FrU – 10 (Picture A).
3. Press the button until the display
shows the GAS parameter (Picture B).
4. Use buttons to select the correct
gas type setting : G20, G25 or G30.
5. Press button for 5 seconds to save
the new setting .
6. Press button to exit hidden menu.
7. To store the new settings disconnect the
oven (unplug it), wait for 10 seconds and
then re-connect it.
C) Apply a label
Apply a permanent label to the rating plate,
specifying the data relating to the new
fitting.
19
1 2
G A S G
2 0
1 2
F
r
U
Picture A
Picture B
Label
Note: The gas type setting on the previous
software version was done on the 2
nd
level
hidden menu:
To enter the hidden menu:
Press simultaneously the + +
buttons for 5 seconds.
To save the new setting:
Press button.
Note: Older versions of software do not
emit the confirmation beep.
Previous Software
*
To Next Page
Loading...
Need help?
General