6. STEAM.Maxi™ Water Inlet
Water in steam circuit
- As required by current laws, the
appliance is equipped with 2 metres of
pipe, the respective pipe fitting (3/4”) with
non-return valve and mechanical filter. If
the pipe fitting is different from the one of
the oven, use a proper adaptor made in
stainless steel or brass.
- Water inlet pressure must be not higher
than 2 bars and not lower than 1,5 bar.
- If the water pressure is too low, use a
pump to increase it.
- The XC665 kit can be used when there is
no water supply. A pump can be fitted in
the unit in order to source water from a
tank. The maximum capacity of the pump
is 14 l/h.
21
Water inlet pipe
XC665 Kit
Max: 14 L/h
To Next Page
Loading...
Need help?
General