Why USAutomatic gate only works when 'LED INDICATOR' is pressed?
If your USAutomatic gate only operates when the “LED INDICATOR” is pressed, verify all wiring on the accessories connected to the J2 connector. If the issue persists, the control board is most likely the problem, and you should contact the factory for further troubleshooting options.
Why USAutomatic gate opens but won't close using transmitter?
If your USAutomatic gate opens using the transmitter but won't close (Low Current Receiver only), the P2 relay may be programmed to latch mode. Refer to page 21 to reset the receiver P2 relay to momentary mode. Also, return to troubleshooting section 4 and perform steps 1-6.
Why won't my USAutomatic PATRIOT I battery stay charged?
The most common reason a USAutomatic Gate Opener battery (AC or Solar Charged) won't stay charged is because the battery is bad. It is highly recommended that the battery be load tested at a battery store to verify that it is good.
What to do if the Charger / Charge Controller “Detection” Light is ON on my USAutomatic Gate Opener?
If the “Detection” Light is ON on your USAutomatic Gate Opener's charger or charge controller, this indicates that the battery is not connected to the charger / charge controller. Check the wiring harness connection to the charger / charge controller.
General| Motor Type | DC |
|---|---|
| Max Gate Length | 20 feet |
| Operating Voltage | 24VDC |
| Battery Backup | Yes |
| Power Source | AC or Battery |
| Control Type | Radio Remote Control |
To Next Page
