17
TO REINSTALL THE HEAT SHOE
1. Be sure laminator is unplugged.
2. Guide heat shoe wires exiting from the right end of the heat shoe through the
slot in the right side of frame.
3. Lower the right end of the heat shoe onto its bracket first, then lower the left end
and lock in place.
4. Plug the heat shoe wires into the terminal block.
5. Re-mount the wiring retainer. Be sure it is in its proper location and the correct
wires are retained.
6. Check to make sure that no components are loose and in the path of the drive
chain or sprockets.
7. Carefully install the right side housing and four Allen head screws.
To Next Page
Loading...
