23
CLEANING FRICTION STUDS
If film rolls begin to shudder or squeak, cleaning of tension assembly is required.
STEP 1:
Remove the film rolls.
STEP 2:
Remove the right side housing.
STEP 3:
Dissemble the friction stud by unfastening
and removing the knob. Photo 23-1.
STEP 4:
Remove the spring, metal washer, leather
washer and the friction stud. Photo 23-2.
STEP 5:
To clean, wipe the mounting hole free of excess
debris. Use rubbing alcohol. Photo 23-3.
STEP 6:
Clean the friction stud groove and leather washer.
Use the Scotch Brite
®
pad from the Cleaning Kit.
STEP 7:
To reassemble, reverse the procedure as noted
above. Reset the tension as on page 13.
Photo 23-1
Photo 23-2
Photo 23-3
To Next Page
Loading...
