To Next Page

To Previous Page

SPECIAL REQUIREMENTS

Do not lay the generator on its side when moving, storing, or

operating it. Oil may leak and damage the engine or your property.

There may be Federal or State Occupational Safety and Health

Administration (OSHA) regulations, local codes, or ordinances that

apply to the intended use of the generator. Please consult a qualified

electrician, electrical inspector, or the local agency having jurisdiction.

In some areas, generators are required to be registered with local

utility companies.

If the generator is used at a construction site, there may be

additional regulations that must be observed.

Keep all cooling holes open and clear of debris, mud, water, etc.

Cooling holes are located on the side panel, the control panel, and the

bottom of the generator. If the cooling holes are blocked, the

generator may overheat and damage the engine, inverter, or windings.

Questions and Answers:

Need help?

Do you have a question about the Usr EV20i and is the answer not in the manual?

Usr EV20i Specifications

General