USTM WS-25-LCD-CLARO - Setting Current Time; Setting Regeneration Time; Input Water Hardness Setting

and
and
and
buttons for 5 seconds
and
and
and
and
and
and
15
EN
6.2. Device programming
If no button is pressed during 1 minute, controller will exit programming mode and the keyboard will be locked.
 Unlock the keyboard by pressing and holding for 5 seconds.
 Press SEL button to enter the menu:
 Set clock - setting the current time,
 Set regen time - setting the time of regeneration start,
 Set water hardness - setting input water hardness in mg / l (ppm).
A table for converting ° dH to mg / l (ppm) is on the control head and below:
°dH
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
mg/l (ppm)
179
197
214
232
250
268
286
304
322
340
357
375
393
411
429
447
464
482
500
518
536
6.2.1 . Setting CURRENT TIME
 Unlock the controller by holding buttons for 5 seconds
 Press SEL button to enter the soener parameters, Set clock parameter
is highlighted on the display
 Press SEL button to enter the clock setting, hours start flashing
 Use
buttons to set the hour
 Confirm with SEL button, minutes start flashing
 Use buttons to set the minutes
 Press SEL button to save changes
 Use key to go to the next parameter
6.2.2. Setting REGENERATION TIME
Regeneration start time aer set flow is programmed at 2:00 a.m. by default.
We recommend leaving this value unchanged.
To change regeneration time:
 Unlock the controller by holding buttons for 5 seconds
 Press SEL button to enter the soener parameters, Set regen time parameter is highlighted on the display
 Press SEL button to enter the parameter, hours start flashing
 Use buttons to set the hour
 Confirm with SEL button, minutes start flashing
 Use buttons to set the minutes
 Press SEL button to save changes
 Use key to go to the next parameter
6.2.3. INPUT WATER HARDNESS setting
 Unlock the controller by holding
 Press SEL button to enter the soener parameters, using the arrows set the Input hardness parameter
 Press SEL button, the first value starts flashing
 Using the buttons set the appropriate hardness value
 Confirm with SEL, the second value starts flashing
 Using the buttons set the appropriate hardness value
 Confirm with SEL, the third value starts flashing
 Using the buttons set the appropriate hardness value
 Press the SEL button to save changes
The head automatically calculates the amount of water to be treated.
and
and
and