USTM WS-25-1650-PRIMO

Need help?

Do you have a question about the USTM WS-25-1650-PRIMO and is the answer not in the manual?

Summary

Softeners Technical Parameters

General Information

Feed Water Quality

Pre-filter

Protection from Flooding

Double anti-flooding protection with brine float valve and overflow elbow. Connect overflow to sewage.

Salt Level

Start-up Instructions

Connecting Hoses and Components

Lubricate seals, use 1/2" drain hose, seal with teflon tape. Follow local codes.

Initial Setup and Filling

Set bypass to service, fill tank with water, add salt, connect controller.

Programming and Regeneration

Program controller, perform manual regeneration. Note hot water precautions.

Compact Softener

Compact Softener Installation

Connect softener per scheme. Install sediment pre-filter before device for protection.

Compact Softener Assembly

Attach by-pass to head, lubricate O-rings, connect hoses. Ensure overflow setup.

Two-Piece Softener

Two-Piece Softener Installation

Connect device per scheme. Install sediment pre-filter to protect control head from impurities.

Two-Piece Softener Assembly

Fill vessel with media, install baskets, attach head, by-pass, and brine/overflow hoses.

BNT Head Programming

Time and Regeneration Settings

Automatic Activation

Initial Activation Sequence

Regeneration Stages and Completion

Maintenance

Basic Maintenance Activities

Salt Refilling Procedure