16
EN
7. Start-up procedure
Set the by-pass valve in water supply mode.
Slowly open the main water supply valve (¼ turn) and wait until deposit tank is filled with water
Aer filling the tank with water open the valve to its maximum
Connect the power supply to the head and to power socket
Add 1 bag of salt to the brine tank
Add ca. 15l of water to the brine tank
Press and hold buttons for 5 seconds to unlock the keyboard
Press the ESC button
Immediate regeneration will start. Wait until full regeneration cycle ends.
fig.3. Bypass
settings
fig.4. Water hardness adjustment
8. Adjusting treated water hardness
Soener allows to adjust supplied water hardness. Adjusting can be done by turning the screw, located on the le side
of mixer connected to bypass. Turning the screw clockwise increases the hardness of water supplied to the object.
It is recommended to set hardness of treated between 4 and 5 German degrees (approx. 89 ppm).
9. Troubleshooting
PROBLEM
Control valve fails
to regenerate
Hard water
No power
By-pass valve is open
Injector screen plugged
Check electrical connection
Close by-pass valve
Extended power outage
No salt in the brine tank
Insufficient water flowing
into brine tank
Hard water in hot water tank
Set time and date
Add salt to the brine tank
Clean injector screen
Check DLFC
Empty hot water tank and fill
it with so water
POSSIBLE CAUSE
POSSIBLE SOLUTION
Water Supply position
By-pass position
Pull the hand pole out
as the direction of the arrow
Pull the hand pole back out
as the direction of the arrow
Raw water in
Raw water in
Soft water out Soft water out
greater
hardness
+
ATTENTION! If treated water is yellow, please repeat regeneration cycle skipping the brining.
To skip brining press ESC when brining cycle starts.
SERV ICE
BYPAS S
SERV ICE
BYPAS S
and
To Next Page
Loading...
