EasyManua.ls Logo

Utax CLP 3721 User Manual

Utax CLP 3721
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1/1
Technical Bulletin
UTAX
UTAX
CLP 3721
CLP 3726
TA
TA
CLP 4721
CLP 4726
TB 01 / Note for the toner installation error
2KW-B081/M
Date: 18-03-2011
T
OPIC
:
Following error message may appear when installing the new toner container. This may be corrected as below.
M
ESSAGE DISPLAYED
:
MFP : “The toner container is improperly installed” Printer : “Check the toner container”
C
ORRECTIVE ACTION
:
Once take out the toner container from the machine. Rotate
the coupling at the right side of the toner container clockwise
to eliminate the gap between the hook of the coupling and the
latch. Then, reinstall it in the machine.
Classification:
Entire Stock Rework
In-Field modification at next visit
X
In-Field modification by case
No modification necessary
Field Measure:
Please check the above and act correctively.
Serial Nos.:
n/a
Toner container
Latch
Hook of coupling
Eliminate the gap
Rotate the coupling CW
to eliminate the gap
Error message may appear
Coupling
Coupling
Enlarged view of section

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Utax CLP 3721 and is the answer not in the manual?

Utax CLP 3721 Specifications

General IconGeneral
BrandUtax
ModelCLP 3721
CategoryPrinter
LanguageEnglish

Summary

TB 01 / Note for the toner installation error

TB 02 / Firmware Upgrade (MAIN 02.005 / ENG. 03.003)

TB 03 / Colour background after setup

CORRECTIVE ACTION

Procedure to correct color background issues.

TB 04 / Corrective measures for C0150 error with...

TB 05 / Corrective measures for the color dot images

TB 07 / Note when adjusting the color registration

TB 09 / Firmware Upgrade (ENGINE 006.002)

TB 11 / Firmware Upgrade (MAIN 003.007)

TB 12 / Firmware Upgrade (color reg. drift / density)

FIRMWARE UPGRADE PROCEDURES

Steps for firmware upgrade.

TB 14 / Firmware Upgrade (V 4.00)

TB 15 / Display message “Close rear cover 1”

TB 16 / Change for the toner container shutter

TB 17 / Firmware Upgrade (V 4.01N)

TB 18 / Paper feed jam at the 250-sheet cassette

TB 19 / Toner supply failure...

TB 21 / The color registration drift due to coming off...

TB 23 / Field measures for color registration shift...

TB-24C Corrective measures for the MP feed clutch motion error (J0509)

PROCEDURES

Steps to correct MP feed clutch error.

TB-25B Firmware Upgrade (Upgrade Pack V 5.01N)

CONTENT OF CHANGES

Firmware upgrade for waste toner box detection.

TB-26S Corrective measures for dog-ear at the second side of duplex print

CONTENT OF CHANGES

Measures for duplex print dog-ear.

TB-28S Notes when assembling the parts (Bottom plate driving gear)

TB-31B Note when cleaning / replacing the feed roller unit

CONTENTS OF THE PERMANENT MEASURES

Permanent measures for feed roller unit.

Related product manuals