4-87
Operation Panel
2 Press [OK]. The Channel screen appears.
3 Enter the Channel number using the numeric keys, or .
4 Press [OK]. The Custom Setup menu reappears.
Netwk Authentic. (Network Authentication setting)
This sets the authentication method to be used when connecting to an access point.
1 In the Custom Setup menu, press or to select Netwk
Authentic..
2 Press [OK]. The Netwk Authentic. screen appears.
The available authentication methods are as follows:
Open
Shared
WPA-PSK
WPA2-PSK
3 Press or to select the desired authentication method.
4 Press [OK]. The Custom Setup menu reappears.
Encryption (Encryption settings)
This selects the encryption settings.
1 In the Custom Setup menu, press or to select Encryption.
2 Press [OK]. The Encryption screen appears.
The following operations are possible:
• Data Encryption (Data Encryption setting)...4-88
• WEP Key (WEP Key settings)...4-88
• Preshared Key (Preshared Key settings)...4-88
Note The Channel can be set between 1 and 11.
Note You can also configure the network authentication setting for WPA-Enterprise and WPA2-Enterprise using
the web page of the optional Wireless Network Interface Kit (IB-51). For details, refer to the IB-51 User's Manual.
Netwk Authentic.:
Open
01
Shared
02
*
WPA-PSK
03
Note WPA-PSK and WPA2-PSK are only displayed when
Infrastructure has been set as the Connection Mode
(Switch between connection modes) on page 4-86.
Note This setting is not displayed when the setting for Netwk Authentic. (Network Authentication setting) on page
4-87 is set to use an authentication method other than Open, Shared, WPA-PSK and WPA2-PSK, using Utility.
Encryption:
Data Encryption
Exit
WEP Key
01
02
Note WEP Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 4-87 is set to Open
or Shared.
Preshared Key is displayed when Netwk Authentic.
(Network Authentication setting) on page 4-87 is set to WPA-
PSK or WPA2-PSK.
To Next Page
Loading...
Need help?
General
