Chapter 3: Installation
Stratos EX Hazardous Area Aspirating Smoke Detection System Installation Manual 33
connected via an RS-232 serial cable. Complete instructions on how to install,
launch and use the the Remote Configuration Software are provided in the
Remote Configuration Software User Manual under separate cover.
SenseNET
The SenseNET software is available for purchase. SenseNET software can
configure and manage a large network of detectors with a simple,
streamlined graphical user interface from a computer connected to a detector
or command module via an RS-232 serial cable or RS-485 converter interface.
Complete instructions on how to install, launch and use the SenseNET software
are provided in the SenseNET Software User Manual under separate cover.
Note: Since the EX does not include a front panel display or keypad,
programmable functions cannot be accessed via the unit itself.
Refer to “Connecting to a PC” on page 34 of this manual for instructions on how
to connect a PC to an EX detector.
List of programmable functions
In both the Remote Configuration and SenseNET programs, the tabbed
Functions Settings window contains all of the available programmable functions.
For details about these functions, refer to the appropriate manuals provided
separately:
• Remote Configuration Software User Manual
• SenseNET Software User Manual
To change one of the programmable functions, go to the relevant tab, make the
change, and then click OK to save the changes to the detector’s internal
firmware.
The following programmable functions are available:
• Time and Date
• Alarm Levels
• Alarm Delays
• ClassiFire Override (when optional Input/Relay card is installed)
• Alarm Factor
• LDD Enable
• FastLearn Enable
• Auto FastLearn Enable
• ClassiFire 3D
• Demo Mode
• Day Start/Night Start
• Disable Day/Night Switching
• Remote Functions (when optional Input/Relay card is installed)
• Programmed Isolate
• Latching Alarms
To Next Page
Loading...
Need help?
General