EasyManuals Logo

UTC Fire and Security Edwards BPS6A User Manual

UTC Fire and Security Edwards BPS6A
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
2 Remote Booster Power Supply Technical Reference Manual
Installation procedure checklist
Follow these steps to install and set up the booster power supply (BPS).
Verify that all power and field wiring are de-energized before proceeding.
Unpack the equipment.
Review the “Getting started” section.
Review the applications: Review the applications to determine how you want
to use the BPS. See the “Applications” section.
Prepare the site: Make sure the installation location is free from construction
dust and debris and extreme temperature ranges and humidity.
Install the enclosure: See “Installing the enclosure” for enclosure dimensions.
Install option modules if required: See “Installing option modules in the
enclosure.”
Install the 3-TAMP tamper switch (if one is used): See “Installing the 3-TAMP
tamper switch.”
Set the jumpers: See “Setting the jumpers.”
Set the DIP switch options: See “Setting the DIP switches.”
Review wire routing: See “Wire routing.”
Check field wiring for shorts, opens, and grounds.
Connect the field wiring: See “Connecting the field wiring.”
Turn on the AC mains power.
Connect the battery compliment.
Verify that no defaults are displayed.
Test the system for proper operation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UTC Fire and Security Edwards BPS6A and is the answer not in the manual?

UTC Fire and Security Edwards BPS6A Specifications

General IconGeneral
BrandUTC Fire and Security
ModelEdwards BPS6A
CategoryPower Supply
LanguageEnglish

Related product manuals