UTC Fire and Security Edwards BPS10A User Manual

Remote Booster Power
Supply Technical
Reference Manual
P/N 3100485-EN • REV 04 • ISS 28AUG12

UTC Fire and Security Edwards BPS10A Specifications

General

Output Voltage	24VDC
Input Voltage	120VAC
Output Current	10A
Operating Temperature	0°C to 49°C
Certifications	UL

Summary

Introduction

Installation Procedure Checklist

Getting Started

Component Descriptions

Specifications

LED Indicators

Installing the Enclosure

Installing Option Modules in the Enclosure

Installing the Circuit Board in the Enclosure

Setting the Jumpers

NAC Class A or Class B (JP1 and JP2)

Configures NAC wiring for Class A or Class B operation using jumpers.

Ground Fault Enable (JP3)

Enables or disables the BPS's ground fault detection for NAC/AUX circuits.

Battery Charging (JP4)

Controls battery charging based on battery size, using a jumper wire.

UL 864 Programming Requirements

Setting the DIP Switches

Sense 1 and 2 Operation (SW1-1 to 3)

Determines the operating mode for Sense 1 and Sense 2 circuits.

Synchronization Control (SW1-4)

Controls the synchronization of signals with one or four-second delay times.

NAC Circuit Operation (SW1-5 to 8 and SW2-1 to 4)

Controls the operation modes (Sense Follow, Continuous, Temporal, Auxiliary) for NAC circuits.

Genesis Mode for Continuous NACs (SW2-5)

Controls NAC operation for Genesis synchronization in continuous mode.

AC Power Loss Reporting (SW2-6)

Determines when a report is sent to the system for an AC power loss.

Auxiliary Control During AC Power Loss (SW2-7)

Class A or B NAC Configuration (SW2-8)

Wire Routing

Common Trouble Relay Wiring

Understanding BPS Synchronization

Access Control Power Supply