1. The light control may be
sensing small animals or
automobile traffic.
2. The range is set too high.
3. The light control is in MANUAL
mode.
1. Reposition the lamp away
from the sensor or nearby
objects.
2. Reposition the sensor.
3. Revert back to the sensor
mode.
1. Heat or light from the lamps may
be turning the light control on
and off.
2. Heat being reflected from other
objects may be affecting the
sensor.
3. The light control is in the TEST
mode and warming up.
4. The light may be leaking
through the flood lamp
reflectors.
1. Reposition the lamps away
from the sensor.
2. Reposition the sensor.
3. Flashing is normal under
these conditions.
4. Make sure the metal lamp
protectors are installed.
CARE AND MAINTENANCE
To clean, turn OFF all power to circuit and clean surfaces with a mild, non-abrasive cleaner.
CAUTION: Turn OFF all power to circuit at main circuit breaker or fuse box. DO NOT rely on
wall switch alone to turn off power.
To make sure the fixture functions properly, always keep the wall switch in the “ON” position
(including the daytime).
WARRANTY
FIVE-YEAR LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship within five (5) years from the date of
purchase, return it along with proof of date of purchase and it will be replaced with the same or
comparable model free of charge.
This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty repair.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL
OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION
MAY NOT APPLY TO YOU.
To Next Page
Loading...
Need help?
General
