8
Installation is now complete. Turn on power at circuit breaker and flip wall switch to ON position.
Wall switch must remain in the ON position for the motion detector to work properly.
OPERATING INSTRUCTIONS
SENSOR SETTING
The sensor will detect movement and
the light will activate regardless of time
of day. After movement has stopped or
left the coverage area, the light will
remain on for about 5 seconds, then
turn off.
Adjust the
“DISTANCE” to the L,
M, H. In default H
At dusk, the motion sensor becomes
active. Any movement within the
coverage area will cause the light to
CAUTION: To avoid water damage and the risk of electrical shock, the motion
sensor controls must be facing the ground when installation is complete.
CAUTION: Ensure fixture is mounted on wall as indicated by icon in lamp base.
Do not mount UPSIDE DOWN to avoid water damage!
To Next Page
Loading...
Need help?
General
