Utilitech 7115-02 - Page 9

9
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS (Continued)
4. Attach the duct connector (C) to the fan housing (A).
A
C
4
5. Remove the three screws (5.1) on the side of the fan
housing (A) that hold the fan motor (5.2) in place. With
the screws removed, unplug the fan motor (5.2) and
pull the fan motor out of the fan housing (A).
5.1
5.2
A
5
6. Remove the wiring box cover (6.1) from the fan
housing (A). Remove the wiring knockout (6.2) from
the wiring box cover (6.1) with a athead screwdriver.
6.1
6.2
A
6