To Next PageTo Next PageWhy is my Utilitech 7105-06 so loud?
To reduce fan noise, ensure that the CFM rating on your Utilitech Fan matches the square footage of your room. Check the damper to ensure it's functioning correctly; if damaged, contact Customer Service. Make sure there are no sharp duct bends within 18 inches of the fan discharge and that you're using the recommended ducting size. Also, verify the fan is securely attached to the ceiling joists.
What to do if my Utilitech Fan is not clearing humidity?
If your Utilitech Fan isn't clearing humidity, ensure sufficient airflow by slightly opening a door or window. The fan needs airflow to draw air out of the room. Also, check that the CFM rating on the fan matches the room's square footage. Note that clearing steam from the room within 15 minutes after a shower indicates proper operation.
What to do if my Utilitech 7105-06 is not clearing the room?
If your Utilitech Fan isn't clearing the room effectively, it could be due to insufficient intake airflow. Make sure a door or window is slightly open to allow airflow, as the fan needs sufficient airflow to draw from. Another reason could be insufficient CFM (Cubic Feet per Minute). Ensure the CFM rating of your Utilitech Fan matches the requirements for your room size. Note that using a tissue is not an accurate method for determining if the fan is operating properly; if the fan clears steam from the room within approximately 15 minutes of completing your shower, then the fan is operating properly.
General| Model | 7105-06 |
|---|---|
| Brand | Utilitech |
| Type | Ceiling Fan |
| Number of Blades | 5 |
| Motor Type | AC |
| Reversible Motor | Yes |
| Control Type | Pull Chain |
| Finish | Brushed Nickel |
| Blade Material | MDF |
| Remote Control Included | No |
| Blade Span | 52 inches |
| Blade Color | Walnut |
Essential safety guidelines and warnings for operating and installing the fan.
Critical safety measures related to electrical connections and power handling.
Lists required tools, estimated time, and preparation steps before installation.
Specifies the physical measurements for ceiling openings and fan housing.
Details electrical wiring compliance, copper wire usage, and provides a wiring schematic.
Provides guidance on duct installation, insulation, and airflow optimization for the fan.
Crucial steps and warnings before commencing fan installation.
Instructions for attaching suspension brackets and mounting the fan housing.
Steps for connecting the duct connector and house wiring to the fan.
Guidance on connecting the LED grille, trim ring, and glass diffuser.
Procedures for cleaning the glass diffuser, fan housing, and grille.
Addresses common problems like fan noise and insufficient humidity clearing.
