Switching off the CryptoServer LAN
5 Switching off the CryptoServer LAN
Before you switch off the CryptoServer LAN, please close down all the applications that
access it.
The following status message in the display panel is the reference point for the next steps. If
you are currently working in a particular menu level or an input screen, quit this by pressing
the EXIT button. You may need to do this several times.
Mode: Operational OK Temp.: 31,0 °C
Trans./min.: 5 Clients: 1
Then use the menu control to switch off the CryptoServer LAN as follows:
1. Click OK.
2. Select the CSLAN Administration menu item and click OK.
3. Use the direction key to go to the Shutdown menu item and then click OK.
4. Use the direction key to select Yes and click OK. This shuts down the device.
When the device is switched off, the message in the display panel disappears. If you want to
switch off CryptoServer LAN completely, switch off the power supply switch 1 on the rear face
of the device.
The CryptoServer LAN should be kept running constantly to prevent the batteries from
being used.
If a system is inactive for a long period, the batteries will be used up. After a while this can
result in the CryptoServer Se no longer being supplied with power, and all the data will be
deleted. The resulting maintenance tasks are not covered by Utimaco IS GmbH's liability.
On the other hand, a brief interruption to the power supply (if the device is being moved
around etc.) does not place a serious demand on the batteries and consequently there is no
danger of data and settings etc. being deleted.
To Next Page
Loading...
