SVD48V series servo driver manual (PC software)
Click the Start Test button under each ppm interface, and the blue stripes display the current remote control channel value.
Toggle the joystick to record the maximum, minimum and intermediate values of the joystick channels 1 and 4 to the
corresponding position on the ppm interface and write data(download data).
The dead zone is the fluctuation range of the channel data, and the fluctuation range of the data is recorded to the
corresponding position on the ppm interface.
The two-gears switch of channel 5 records the maximum and minimum values, and the middle value takes the average of the
maximum and minimum values.
Channel 6 the three-gears switch, 3 position corresponds to the maximum value(ppm4 max), the minimum value(ppm4
min) and the middle value(ppm4 center).
Filter frequency, max 1000 Indicates 100hz cutoff frequency, set to 0 Indicates no filtering. The smaller the value, the more
obvious the filtering effect, but the more lag, that is the performance is not following well. Filter frequency recommended value
100 ~ 200 , or no filtering.
Reversal, a value of 1 or 0, adjusts the reverse control .
Scale, that is, the percentage coefficient, the default is 100% , which means that the value is not reduced, and 50%
means that the value is reduced by half. Remember to write the parameters to the driver(controller) to save data after
setting is done.
4.8.1.2.
Set up the mapping function
After all channels are calibrated, start setting up the mapping function for each channel. The mapping function of all
channels cannot be repeated(cannot be the same), and the unused channels mapping function should be off.
If you only want to control the forward rotation of the motor, select only the option with FORWARD; if you only want to
control the motor reverse rotation, select only the option with REVERSES; if you want to control the motor forward and
reverse rotation, only select the option with FORWARD_AND_REVERSES.
PPM1 is mapped to TWO_MOTOR_SPEED_FORWARD_AND_REVERSES , that is, the remote control channel 1
To Next Page
Loading...
Need help?
General