Uwatec Aladin 2G User Manual

39
English
SCUBAPRO ALADIN 2G
6. Diving with microbubble (MB) levels
(Max depth >) Temperature
> MB level active
> No-stop time relative to L0
> Temperature and time of day
> (Max depth)…
)
NOTE:
Whereas the quantitative information relative to L0 can be seen by pressing the right
button, qualitative information is always visible on the display in form of the nitrogen
loading bar. In particular, when the L0 no-stop time is less than three minutes,
the nitrogen bar will flash ->27. This will help you avoid entering inadvertently into
decompression.
6.2.2 Display during level stop phase
Lowest level
stop depth
Total ascent time (14min)
3min
Level stop duration
MB no-stop phase
Time
Depth
Level stop duration
The duration of a level stop
at a given level stop depth
is displayed.
Level stop
depth
The deepest level
stop is displayed.
Total ascent time
including level stops
Level stop phase
To complete the dive without cascading
to a lower MB level all requested
level stops must be observed.
35.7m
9m/30ft
6m/20ft
3m/10ft
STOP
S
L
O
W
CNS O
2
%
DEPTH
DIVE TIME
Nitrogen
loading bar
relative to LO
->26
(Max depth >) Temperature
> MB level active
> No-stop time or deco information relative to L0
> Temperature and time of day
> (Max depth)…
6.3 Preparation for a dive
with MB levels
6.3.1 Setting the MB level
To change the MB level Aladin 2G must be
in user mode (time of day display).
or until
1. Push or until the symbol for
MB levels
appears.
2. Confirm that you wish to change the
displayed MB level by pushing .
3. Change MB level by pushing or
.
4. Confirm the selected MB level with .
Without confirmation the display will
disappear after 3 minutes and your entries
will not be accepted.
Aladin 2G will display the
symbol to
confirm that an MB level beyond L0 (L1-
L5) has been chosen. During the dive the
->27

Uwatec Aladin 2G Specifications

General

Brand	Uwatec
Model	Aladin 2G
Category	Diving Instrument
Language	English