The display “7: 3m” means that a
decompression stop of 7 minutes at a
depth of 3m/10ft has to be made.
When a decompression stop has
been completed, the next (shallower)
decompression stop is displayed.
When all decompression stops have been
completed, the “DECO STOP” symbol
disappears and the “NO STOP” symbol
along with the no-stop time reappears.
Deco stop depths deeper than 27m/90ft
are displayed as “ – – : – – ”.
Ignored decompression alarm
WARNING
The decompression alarm is activated if the
decompression stop is ignored. The “DECO
STOP” arrow, the decompression stop duration,
and the decompression stop depth begin to
ash and an audible alarm sounds. Due to the
formation of microbubbles, decompression
can increase massively if a decompression
stop is ignored. Descend to the prescribed
decompression stop depth immediately!
When the surface is reached during the
decompression alarm, the “DECO STOP”
arrow, the decompression stop duration,
and decompression stop depth continue
ashing in order to point to the risk of a
decompression accident. The SOS mode
is activated 3 minutes after the dive if
corrective action is not taken. If the total
(cumulative) duration of the decompression
alarm is longer than one minute, it is
entered in the logbook.
3.4.12 Total ascent time
Total Ascent
Time
As soon as decompression stops are
necessary, the Aladin Sport shows the
total time of ascent. This includes the
ascent time from the current depth to the
surface as well as all decompression stop
obligations.
F
NOTE: The total time of ascent
is calculated on the basis of the
prescribed ascent rate. Total time of
ascent can be subject to change if
the ascent rate is not ideal (100%).
Ascent time greater than 99 minutes
is displayed as “ – – ”.
WARNING
On all dives with the Aladin Sport, make a safety
stop for at least 3 minutes at a depth of 5m/15ft.
3.4.13 Safety stop timer
Safety Stop Icon
Safety stop time (minutes, seconds)
The safety stop timer displays the time a
diver should spend at the safety stop depth
at the end of the dive. The timer starts
automatically when depth is shallower than
5m/15ft and counts back from 3 minutes
(default) to zero. It can be restarted manually
any number of times. The duration of the
timer can be set between 1 and 5 minutes.
To Next Page
Loading...
Need help?
General
