the depth and the no-stop time for that
depth.
• If a MB level has been selected (L1-L5),
the MB no-stop time is shown.
• Depths deeper than the MOD for the
selected gas (O
2
mix) are not displayed.
• If the deco gas option is turned on, only
the depth between the MOD of gas 1
and the MOD of gas d are displayed.
F
NOTE: The no-dive warning and its
duration are displayed if the Aladin
Sport detects an increased risk due to
the accumulation of microbubbles.
* For more information and safety
considerations regarding the no-dive
warning, see chapter: Diving with your
Aladin Sport, section: Desaturation
time, No-fly time and No-dive warning.
4.2.2 Planning a decompression
dive
1. Activate the dive planner.
2. Set the desired depth by pressing the
left or right button and then conrming
with a press-and-hold of the right
button. The Aladin Sport shows the
bottom time (no-stop time + 1 minute)
and the appropriate decompression
information or level stop data,
respectively.
3. “Add” asks that you set the bottom
time. This is done by pressing the left or
right button. The Aladin Sport calculates
the decompression information for this
set bottom time. If a MB level (L1-5) is
selected, the Aladin Sport calculates the
level stop data.
CNS O
2
% values higher than 199% will be
displayed as 199%.
Ascent time greater than 99 minutes is
displayed as “– –”.
Deco stop depth deeper than 27m/90ft is
displayed as “– –: – –”.
CNS O
2
equal or greater than 75%: CNS
O
2
% symbol starts ashing.
CNS O
2
equal or greater than 100%: CNS
O
2
% symbol and CNS O
2
% value are
ashing.
MB level stop deeper than 27m/90ft: MB
level will be reduced.
4.2.3 Leaving the dive planner
By pressing-and-holding the right button at
the time eld you can exit the dive planner.
This will also occur after 3 minutes without
operation.
To Next Page
Loading...
Need help?
General
